 |
 |
|
|
Home  Morbark Model 1300B |
OPTIONS
- Wireless remote control
- Electric over hydraulic power pack
- Magnetized end pulley with collecting slide tray for ferrous metal extraction
- Hydraulic reversing radiator fan
- Hydraulic rod pusher
- Dust suppression system
- Rotating cab (340°)
- Radial stacking conveyer
- Available with no cab and loader
|
 |
|
|
IQAN SYSTEM
Automatically adjusts tub rotation and monitors pressures to maximize
production and engine efficiency.
|
HYDRAULIC CLUTCH
With hydraulic clutches from Twin Disc or PT Tech, there is no need for clutch
adjustments and maintenance costs are
greatly reduced. |
HYDRAULIC AUGERS
Quickly remove product from beneath the mill and during material surges, pressure sensors automatically slow tub rotation to prevent plugging. |
HAMMERMILL
Laser-cut, factory balanced hammermills
with forged hammers offer unsurpassed
durability and smooth operation. |
GENERAL
Length (transport) ........................................45’
Length (operating) .....................................63’6’’
Height ................................................13’ 6”
Width .................................................11’ 11”
Gross weight ....................................83,660 lbs.
Axle weight .......................................53,480 lbs.
Tongue weight .....................................28,740 lbs.
Engine .........................................CAT or Cummins
Horsepower ................................ 760 HP to 1,050 HP
Fuel capacity (tank) ............................505 gallons
Hydraulic oil capacity ............................205 gallons
Iqan System
Wireless radio remote control
TUB
- Full hydraulic tilt
- 13’ diameter tub opening, 10’ diameter at inside base and 60” deep
- Walls constructed of 3/8” thick reinforced steel plate, floor constructed of 1⁄2” thick T-1 steel
- Replaceable wear strips on the tub floor
- Tub supported by 16 rubber tire guide rolls, carried on a 11⁄2” diameter chrome shaft
- Hydraulic forward and reverse
- Safety shut down system
- Electronic RPM sensor for tub drive
HAMMERMILL AND SCREEN
- 31” x 64” hammermill opening
- 20” x 63” rotor with eight 21/4” heat-treated hammer retaining rods mounted on an 7” diameter rotor shaft
- 303/8” tip swing with double-edged, replaceable cutting tools
- 1” thick wear form steel split screens
- Wear plate and screen area 3,730 sq. inches
DISCHARGE SYSTEM
Two 16” diameter augers discharge onto a 40” x 31’ heavy duty belt conveyor
Discharge height of 17’
CAB AND LOADER
Enclosed weatherized operator’s cab with six-way adjustable seat, complete with all controls and air conditioner and heater
Morlift model 400 knuckleboom loader with 29’ extended reach, 280° continuous swing with a 36” tarantula grapple with 360° turn
Lift capacity 9,619 lbs. at 10’
Click below for the pdf file
 1300b 238.23 Kb
|
|
|
