|
OPTIONS
- Electric over hydraulic power pack
- Wireless remote control
- Heavy-duty 36” grapple
- Magnetized end pulley with collecting slide tray for ferrous metal extraction
- Hydraulic reversing radiator fan
- Dust suppression system
- Available with no cab and loader
|
 |
|
|
|
HAMMERMILL
Laser-cut, factory balanced hammermills with forged hammers offer unsurpassed durability and smooth operation.
|
HYDRAULIC AUGERS
Quickly remove product from beneath the mill. During material surges, pressure sensors on the auger system automatically slow tub rotation to prevent plugging.
|
TORQUE LIMITER
The full breakaway torque limiter system protects the engine and clutch against shock and overload without stalling the enigne.
|
Tub Tilt
Provides easy access to grates and anvil for routine maintenance.
|
Specifications
GENERAL
Length (transport) ...........................................................38’2’’
Length (operating) ..........................................................57’3’’
Height .................................................................................13’ 6”
Width .................................................................................11’11”
Gross weight ........................................................67,880 lbs.
Axle weight .............................................................47,000 lbs.
Tongue weight ......................................................20,880 lbs.
Engine ...........................................................CAT or Cummins
Horsepower ............................................. 630 HP to 860 HP
Fuel capacity (tank) ..........................................300 gallons
Hydraulic oil capacity ........................................205 gallons
Wireless radio remote control
TUB
Full hydraulic tilt with dual hydraulic tub drives
12’ diameter tub opening, 9’ diameter at inside base and 62” deep
Walls constructed of 3/8” reinforced steel plate, floor constructed of 1⁄2” T-1 steel plate
Hydraulic forward and reverse
Safety shut down system
Electronic RPM sensor for tub drive
Tub cover for debris containment
HAMMERMILL AND SCREEN
29” x 52” hammermill opening
161/2” x 511/4” rotor with eight 2” heat-treated retaining rods mounted on an 57/8” diameter rotor shaft
27” tip swing
Equipped with (24) 2” thick T-1 steel fixed hammer with double- edged replaceable cutting tools
1” thick wearform steel split screens
DISCHARGE SYSTEM
6000 Char-Lynn motor drive, two 14” diameter augers onto a 36” x 28’ heavy duty belt conveyor
Discharge height of 15’
CAB AND LOADER
Enclosed weatherized operator’s cab with sixway adjustable seat, joystick controls and air conditioner/heater
Morbark model 350 knuckleboom loader with 24’ extended reach and 280° continuous swing by-pass grapple with 360° turn
Lift capacity 8,300 lbs. at 10’
Hydraulic outriggers
Click the link below for the pdf file:
 1200XL 236.75 Kb
|
