Magnetized end pulley with slide tray for ferrous metal removal.
Full breakaway torque limiter.
Auxiliary air compressor.
Six function wireless remote.
12' tub flare.
Available with no cab and loader.
GENERAL
Length (transport) ...........................................................37’2"
Length (operating) ........................................................56’3’’
Height .................................................................................13'6”
Width .......................................................................................11’ 2"
Gross weight ........................................................59,320 lbs.
Axle weight .............................................................39,780 lbs.
Tongue weight ......................................................19,540 lbs.
Engine ...........................................................CAT, Cummins or John Deere
Horsepower ...................................... 440 HP to 760 HP
Fuel capacity (tank) ..........................................160 gallons
Hydraulic oil capacity ........................................205 gallons
Wireless radio remote control
TUB
Full Hydraulic tilt
11' diameter tub opening, 9’ diameter at inside base and 62” deep
Wall constructed of 3/8” reinforced steel plate, floor constructed of 1/2” T-1 wear-resistant steel
Tub supported by 14 rubber tire guide rolls carried on a 1 1/2” diameter chrome shaft
Hydraulic forward and reverse
Safety shut down system
Electronic Rpm sensor for tub drive
Tub cover for debris containment
HAMMERMILL
Laser-cut, factory balanced hammermills with forged hammers offer unsurpassed durability and smooth operation.
HYDRAULIC AUGERS
Quickly remove product from beneath the mill. During material surges, pressure sensors on the auger system automatically slow tub rotation to prevent plugging.
TORQUE LIMITER
The full breakaway torque limiter system protects the engine and clutch against shock and overload without stalling the enigne.
TUB TILT
Provides easy access to grates and anvil for routine maintenance.
HAMMERMILL AND SCREENS
26” x 52” hammermill opening
16” x 44" rotor with eight 2" heat-treated hammer retaining rods mounted on a 7/8" diameter rotor shaft
24” tip swing
Equipped with (27) 2” thick fixed hammers with 3" inserts
1” thick AR-400 wear from split screen
Wear plate and screen area 2,424 sq. inches.
DISCHARGE SYSTEM
Two 14” diameter augers discharge onto a 36" x 28' belt conveyor.
