Available in a “Super 1000” version, which includes tandem axle and a 12’ tub flare
Magnetized end pulley with slide tray for ferrous metal removal.
Full breakaway torque limiter or PT Tech torque limiting device.
Electric power.
Auxiliary air compressor.
Six function wireless remote.
Fifth wheel towing arrangement with dual axles and hydraulic stabilizers.
GENERAL
Length (transport) ...........................................................28’1"
Length (operating) ........................................................48’2’’
Height .................................................................................12’6”
Width .......................................................................................8’ 6"
Gross weight ........................................................27,840 lbs.
Axle weight .............................................................19,820 lbs.
Tongue weight ......................................................8,020 lbs.
Engine ...........................................................CAT, Cummins or John Deere
Horsepower ...................................... 325 HP to 475 HP
Fuel capacity (tank) ..........................................160 gallons
Hydraulic oil capacity ........................................80 gallons
Wireless radio remote control
TUB
Full Hydraulic tilt
10’6” diameter tub opening, 8’ diameter at inside base and 50” deep
Wall constructed of 1/4” reinforced steel plate, floor constructed of 3/8” thick T-1 wear-resistant steel
Tub supported by 10 rubber tire guide rolls carried on a 1 1/2” diameter chrome shaft
Hydraulic forward and reverse
Safety shut down system
Electronic Rpm sensor for tub drive
Tub cover for debris containment
HAMMERMILL
Laser-cut, factory balanced hammermills with forged hammers offer unsurpassed durability and smooth operation.
HYDRAULIC AUGERS
Quickly remove product from beneath the mill. During material surges, pressure sensors on the auger system automatically slow tub rotation to prevent plugging.
TORQUE LIMITER
The full breakaway torque limiter system protects the engine and clutch against shock and overload without stalling the enigne.
TUB TILT
Provides easy access to grates and anvil for routine maintenance.
HAMMERMILL AND SCREENS
26” x 46” hammermill opening
16” x 44" rotor with eight 1 1/4" heat-treated hammer retaining rods mounted on a 4 1/2" diameter rotor shaft
24” diameter tip swing
Equipped with (36) 1” thick fixed hammers with 1 1/4" inserts
3/4” thick AR-400 wear from split screen
DISCHARGE SYSTEM
Two 12” diameter augers discharge onto a 28" x 26' belt conveyor
Features
Forward / Reverse wireless remote control Swing hammers
