Magnetized end pulley with collecting and slide discharge for nails and metal extraction.
Full breakaway torque limiter
Electric power
Variety of conveying and material handling equipment.
Auxiliary air compressor.
GENERAL
Length (transport) .........................................................31'
Height .........................................................................13'
Width ...........................................................................8’ 6"
Gross weight ........................................................35,880 lbs.
Axle weight .............................................................27,300 lbs.
Tongue weight ......................................................8,580 lbs.
Engine ...........................................................CAT, Cummins or John Deere
Horsepower ...................................... 325 HP to 475 HP
Fuel capacity (tank) ..........................................160 gallons
Hydraulic oil capacity ........................................120 gallons
Wireless radio remote control
TUB
Full Hydraulic tilt
10’6” diameter tub opening, 8’ diameter at inside base and 50” deep
Wall constructed of 1/4” reinforced steel plate, floor constructed of 3/8” thick T-1 wear-resistant steel
Tub supported by 10 rubber tire guide rolls carried on a 1 1/2” diameter chrome shaft
Hydraulic forward and reverse
Safety shut down system
Electronic Rpm sensor for tub drive
HAMMERMILL
Laser-cut, factory balanced hammermills with forged hammers offer unsurpassed durability and smooth operation.
HYDRAULIC AUGERS
Quickly remove product from beneath the mill. During material surges, pressure sensors on the auger system automatically slow tub rotation to prevent plugging.
TORQUE LIMITER
The full breakaway torque limiter system protects the engine and clutch against shock and overload without stalling the enigne.
TUB TILT
Provides easy access to grates and anvil for routine maintenance.
HAMMERMILL AND SCREENS
26” x 46” hammermill opening
16” x 44" rotor with eight 1 1/4" heat-treated hammer retaining rods mounted on a 4 1/2" diameter rotor shaft
24” tip swing
Equipped with (36) 1” thick fixed hammers with 1 1/4" inserts
3/4” thick T-1 steel heavy duty split screens
Wear plate and screen area 2,424 sq. inches.
DISCHARGE SYSTEM
Two 12” diameter augers discharge onto a 28" x 12' conveyor
36" hydraulic chip thrower with swival discharge and directional tilt mounted on conveyor
