Recycling Systems Australia - Tub Grinders, Chippers, Wood Hogs, Conveyors, Ship & Barge Loaders

FEATURES

• Produces clean pulp and paper chips at rates in excess of 100 tons per hour while processing whole trees ranging from two to 27 inches in diameter.
• Hydraulic flail drive is standard equipment on the 2755.
• Air curtain, rear hydraulic stabilizers, five live boittom feed rolls.
• Delux operator's seat and extended debris conveyor.

GENERAL

Overall Length  ...........................................................55’
Transport Height  ........................................................13’6”  
Transport Width ...........................................................11’ 11" 
Gross weight (approx)   ............................................114, 680 lbs.
Tri-Axle trailer ..........................................................67, 500 lbs, suspension.
Tires (12).................................................................22.5 x 75R x 14 ply radials.
Engine ..................................................................CAT or Cummins 
Horsepower (flail) ................................................. 365 - 375 HP 
Horsepower (chipper) ..............................................755 HP 
Drive (flail) .................................................. Hydraulic
Drive (chipper) ...............................................belt
Towing arrangment ...................................... Fifth wheel 
Fuel capacity (tank)   ..........................................310 gallons
Hydraulic oil capacity (flail) .....................................130 gallons 
Hydraulic oil capacity (chipper) ................................200 gallons 

Cab and Loader

• Enclosed, weatherised operator's cab mounted on rubber shock absorbers, tilts hydraulically for transport 6-way adjustable seat and joy stick controls and combination air conditioner / heater.
• Morlift model 500 knuckleboom, 270 degree swing 23' reach, 360 degree continuous rotation grapple.
• Lift capacity of 17,200 lbs at 10'

Telescoping debris conveyor offers easy setup and the ability to feed debris for fuel processing directly into the Morbark tub grinder or wod hog without handling	Closed loop hydraulic drive system allows the operator to individually control flail RPMs from the cab.	Standard hydraulic flail drive system cuts weight, improves efficiency and provides more precise debarking control.	The 55" wide patrented flail infeed spreads and holds multiple stems from 2 - 27" in diameter for maximum debarking.

Flail

• Infeed opening 27" x 55"
• 3 top feed rollers mounted on yoke assemblies
• 5 stationary bottom feed rollers
• 2 horizontal chain flails with segmented drums are equipped with eight flail chain rods each.  Each rod holds 11 chains or tube-type drums equipped with 6 flail chain rods each, each rod holds 13 chains.
• Top flail drum set in pivoting yoke assembly.
• Bark discharge conveyor, 60" wide x 23" long drag chain, hydraulically driven, telescoping for transport, discharge height of 11".
• Air curtain.

Chipper

• 27" diameter chipping capacity
• 83" diameter chipper disc, 3 knife configuration.
• Chip sizes:  5/8", 3/4", 7/8", or 1"
• Dirt seperator bottom discharges onto the bark and debris augers conveyor.
• Hydraulic swivel / telescoping discharge spout. 

Options

• 4 knife chipper disc
• Third flail drum
• Top loading discharge system
• Halogen light package
• Mechanical drive on two main flail drums
• Single power unit (860 - 1050) (2 drum only)