www.recyclingsystemsaus.com.au

FEATURES

• Designed to produce clean pulp and paper chips at high rates, even when processing pre-commercial thinnings, non-merchantable and juvenile timber.
• Weatherized operator's cab with combination air conditioner / heater.
• Twin disc hydraulic clutch, twin auger discharge, two seperate hydraulic tanks for enhanced oil cooling abd telescoping debris conveyor.
• Hydraulic flail drive is also standard equipment.
• Digital tachometer and speed control dial for each flail drum.

GENERAL

Overall Length  ...........................................................48’
Transport Height  ........................................................13’6”  
Transport Width ...........................................................12’ 
Gross weight (approx)   ............................................105, 000 lbs.
Tri-Axle trailer ..........................................................75, 000 lbs, suspension.
Tires ......................................................................295/75R 22.5, 14 ply radial.
Engine ..................................................................CAT or Cummins 
Horsepower (chipper / flail) ................................ 1000 HP 
Drive (flail) .................................................. Hydraulic
Drive (chipper) ...............................................belt
Towing arrangment ...................................... Fifth wheel 
Fuel capacity (tank)   ..........................................310 gallons
Hydraulic oil capacity (flail) .....................................200 gallons 
Hydraulic oil capacity (chipper) ................................300 gallons 
Wireless radio remote control

Cab and Loader

• Enclosed, weatherised operator's cab mounted on rubber shock absorbers, tilts hydraulically for transport 6-way adjustable seat and joy stick controls.
• Morlift model 500 knuckleboom, 270 degree swing 23' reach, 360 degree continuous rotation grapple.
• Lift capacity of 17,200 lbs at 10'
• Combination air conditioner / heater

Standard hydraulic flail drive system cuts weight and improves efficiency	Morbark's system provides more precise debarking control and ensures superior chip quality.	Closed loop hydraulic drive system allows the operator to individually control flail RPMs from the cab.	The 55" wide patrented flail infeed spreads and holds multiple stems from 2" to 23" in diameter for maximum debarking.

Flail

• Infeed opening 23" x 55"
• 3 top feed rollers mounted on yoke assemblies
• 5 stationary bottom feed rollers
• 2 horizontal chain flails with segmented drums are equipped with eight flail chain rods each.  Each rod holds 9 chains or tube-type drums equipped with 6 flail chain rods each, each rod holds 11 chains.
• Top flail drum set in pivoting yoke assembly.
• Bark discharge conveyor, 60" wide x 23" long drag chain, hydraulically driven, folds for transport, discharge height of 11".
• Air curtain.

Chipper

• 23" diameter chipping capacity
• 75" diameter chipper disc, 3 - 6 knife configuration.
• Dirt seperator bottom discharges onto the bark and debris augers
• Hydraulic swivel / telescoping discharge spout. 

Options

• 4 knife chipper disc
• Third flail drum
• Top loading discharge system
• Halogen light package